First: simple bending of copper wire

1. Replace the copper part cut by the flocking machine head. 2. Replace the worn copper cutter. 3, planting hair and copper knife adjustment is not appropriate, from the beginning adjustment. 4. Remove and remove the foreign body in the heart contact surface between the hair planting head and the hair planting head. 5. If the height of the copper cutting knife is not adjusted properly, adjust it from the beginning; Make the copper wire too long and shorten it. 6, bad quality copper wire, such as bending, too wide or too thick, replace the new copper wire.

Second: planting machine copper wire size piece, copper wire cut after the length of the different. 1, copper wire clip wear, polished from the beginning or replace. 2, copper wire stopper wear, copper wire stopper face change use or replace.

Third: the copper wire into the brush handle when the point of view is wrong, causing the copper wire can not be stuck brush bristles or copper wire simple adjustment. 1. Copper wire size piece, refer to copper wire size piece. 2. Copper wire adjustment is too short. 3. The spacing between the hair planting head and brush handle is too large, so adjust the spacing before and after. 4. Wear, smooth or replace the front end of the hair planting needle. 5. Wear out the front outlet of the planting head, replace the plant of the planting head planting machine.

Fourth: the high speed toothbrush planting machine bristles tension is insufficient. Copper wire is too short, adjust the length. 2, the hair planting depth is not good, the hair planting needle length. The bristles length is not even (all), the direction of the brush hole is not adjusted properly, adjust the brush handle from the beginning. Improper adjustment of up and down, azimuth brush height, adjust the height of the hair support and the hair support.